Irrigation Installation, Maintenance, and Repairs
Design:
We design our systems so that each sprinkler head will spray to another head. This technique supplies even water distribution and the right amount of water for each geographic area of your property.
Our designs are based on the areas to supply water to, water pressure, and gallons per minute given. We do our designs by the ways of the books, unlike many of our competitors! We even supply you with a scale drawing for reference of where the heads and pipes are located; any knowledgeable contractor should be able to read the plan and avoid damage to the system if digging is required later.
Installation:
We use a 4'' trencher attachment on a mini skid steer to trench lines for new installations. We backfill and compact each trench upon completion and patch with sod or seed when the budget allows.
We install Hunter products, and use class 200 pipe on most properties.
Repair:
We service all major brands!*
We can:
-Raise or lower a head
-Move a head
-Fix broken water lines
-Add or replace heads
-Adjust heads
-Install a new timer
-Fix valve problems
-Install rain sensors
-Expand your current system
-Convert overhead shrub beds to drip irrigation
-Whatever you throw at us, we have a solution!
*We only cary Hunter products, and hunter products will replace any broken valve, head, or timer.
We cary tools to adjust most brands.
If you still have a knob irrigation timer, it is time to replace and add a rain sensor to your system!
Winterization:
We first test the entire system and document its functions, next we turn off the controller and turn off the water supply at the backflow.
In the spring, we turn the system back on, run each zone, and adjust spray patterns as needed. Any repairs documented during the shut off will be completed during the start up service.
